🐼 Audi A6 Headlights Not Working Moim zdaniem pomyliłeś się.

If you're lucky, the problem could simply be a blown fuse. Pull the cover from the fuse panel, located on the lower driver's side dash, and locate the headlight fuses (20 and 21 are the low beam fuses). Pull them out and check to see if they are blown, and if so, replace them. 2008 Audi A6 with headlight issues. The Automotive Technician. 8.89K subscribers. Subscribe. 8.7K views 3 years ago. 2008 Audi A6 with headlight issues To find out more or join TaT visit www.tat Support. Hello I've got an issue with my Audi A6 2012 (C7) the driver side headlight stopped working due to water damage , I've now changed the light and both modules and the light is still not working, however when the light is switched to the other side it works as it should but when replaced to its ori I had the problem with the right turn signal and headlights, but not the interior lights. The problem was in one of the fuses located under the steering wheel- need to take the whole under-assembly apart to get to it. Not very hard. But after I replaced the blown fuse and HID LIGHT, fuse blew again. Common wiring problem if you are getting the Adaptive Light Defective warning. This is on a 2007 Audi A6. One fuse on both non-adaptive headlights makes the most sense to me and also jives with the theory that the OP's problem is probably connector related and not fuse related since one light still works. (I hate the Audi fuse and wiring diagrams, so many variants and asterisk notes.) 2023 e-tron GT Daytona Gray. Figure 1. You may see this message on your dash. Step 2 - Is it a broken wire? If the adaptive headlights fail to adjust at all, there is a possibility that the one of the wires going to the adaptive headlight motor could have been pinched or torn. The only way to know for sure is to open up the headlight and check. Hi guys, My headlights not working it states a bulb is blown, but it's not the bulbs, I was told it's a ballast, but purchased a ballast and that doesn't seem to be the problem either, it was initially one light not working,, but now after a guy (auto elec) looked at it both lights are now not wo 11K views 3 years ago #AudiA6 #MrCarMAN. On this video, I am going to be sharing with you on how to change the headlight ballast on your Audi. If your headlight is not working, this might Driver's side headlight issue On a recent trip with my 2014 A4 I received a loud beep and dashboard message letting me know that my driver's side high/low beam headlight had stopped working. I ordered a replacement xenon bulb (D3S model), and because it was the driver's side bulb and therefore easily accessible, decided to install it myself. 3. If the headlights are OK and the fuses are OK, then the problem is *LIKELY* the headlight switch. In my case, AutoZone has one and it can be installed easily; but in your case, that may not be as simple. Please post your findings or comments. Jul 16, 2008 • 1991 Nissan Pickup. Audi A6 C6: Diagnostic Guide for Adaptive Headlight Problems. Adaptive headlights are one of the most complex mechanical features in the Audi A6 C6. This article will explain some of the ways you can solve problems with adaptive headlights. This article applies to the Audi A6 C6 (2005-2011). 1 First Name: vee Location: Hong Kong Audi Model:: A6 2.8 Audi Year: 2010 Posted April 12, 2022 (edited) I am restoring an Audi A6. Both head lights did not work. Removed them and stripped them to find all the internal cabling gutted. The HID controllers had signs of water damage. Set off home this evening and warning came up on dash for light fault. The driver side headlight was not working. Got home and changed bulb, but still not working, so tried bulb from other side (working) and still did not work on driver side. Main beam and side light ok. Could this be a fuse issue? .